Our Lathe department is packed with high-quality equipment including our Okuma LB 1511-M CNC Lathe, Mori-Seiki NLX2500SY/700 CNC Lathe with Sub-Spindle, and the Tsugami B0325-II Swiss Turning Center with an Edge Patriot 338 magazine load bar feeder. All of our operators are responsible for their own quality, setups and problem solving. If you can read complex blueprints and edit programs on the CNC equipment, then you may be a great fit!

Some general job duties for this position include but are not limited to:

• Transfer programs to/from the computer
• Zero Set parts
• Touch off points and demonstrate how to perform them
• Single block through a program cycle
• Adjust chuck and ram pressure
• Change chucks
• Reposition tailstock
• Demonstrate tool changes with VDI turret (3ax)
• Demonstrate touch off procedure for live tooling (3ax)
• Program G and M codes at the lathe (2ax and 3 ax)
• Program new parts from part print in an efficient manner (2ax and 3ax)
• Familiar with multi-spindle (2) machine

Night Shift: 4:30pm to 3am

Job Type: Full-time

Salary: $18.00 – $26.50 per hour